This circuit is called LED Pulse. This circuit is a simple design circuit for application the LED. In principle, the operation mode is obtained by the triangular wave generator formed by two op-amps in a very cheap 8 pin IC Dil cases. Q1 ensures current buffering, in order to get a better load drive. This is the figure of the circuit.
R4 & C1 are the components, the circuit where this total time about 4 seconds. If the value of R4 to adopt is under 220K, the pulsing effect of the peculiar effect of flash. Do not supply the circuit with the voltage exceeds 6V. At 6V supply, increase the value of R6 to 100 Ohm.
Part :
R1, R2 = 4K7
R3 = 22K
R4 = 2M2
R5 = 10K
R6 = 47R
C1 = 1µF
D1 = LED
IC1 = LM358
Q1 = BC337
R4 & C1 are the components, the circuit where this total time about 4 seconds. If the value of R4 to adopt is under 220K, the pulsing effect of the peculiar effect of flash. Do not supply the circuit with the voltage exceeds 6V. At 6V supply, increase the value of R6 to 100 Ohm.
Part :
R1, R2 = 4K7
R3 = 22K
R4 = 2M2
R5 = 10K
R6 = 47R
C1 = 1µF
D1 = LED
IC1 = LM358
Q1 = BC337
No comments:
Post a Comment