This is a
design circuit for temperature relay that can be used to
signal a fire or set point for temperature monitoring function. You need to
adjust P1 so that T1′s base voltage is 0.5V smaller than the emitter voltage at
a temperature a little bit lower than the desired triggering (switching)
temperature. This is the figure of the schematic circuit;
If
the temperature increases then T1 and T2 start conducting and the relay is
closed (ON). If you want to use it as a cold relay or to signal an inferior
temperature limit, then Th1 and P1 change places. After the relay is triggering
you need to open switch S1 in order to stop the circuit. The nominal value of
P1 must be chosen according to the used NTC thermistor and the switching
temperature to be adjusted.
No comments:
Post a Comment